Starting to focus more on this as I want to try for my first engine test run in January !
The fuel bits I have got don’t quite match up as the angle tube at the bottom doesn’t match the thread of the lower tank fitting .. will check with TLAC.
Update 18 December – Paul emailed to say that the elbow connector I had sent back was indeed correct – it’s a tapered fit so deliberately tight to ensure a good tight fuel proof seal. I have the steel braided fuel tube and it is already routed through the firewall, so just need some pipe clamps.
Noticed my single bus bar has a top and a bottom row so should be able to use this bar for positive and negative feeds. The next stage is to cross check the Jabiru manual – page by page – to check I have all the parts before starting to plan wiring up.
Jersey Sherwood Ranger 
Leave a Reply